Stan Posted September 19, 2006 Report Share Posted September 19, 2006 I was searching for an answer for this on the forum and no luck.The problem here is why since the version 1.6 uT is VERY slow solving the peers addresses. There is any way to do to this quickly like in 1.5 and below?The only solution is back to a lower version?Thanks Link to comment Share on other sites More sharing options...
Game90 Posted September 19, 2006 Report Share Posted September 19, 2006 it only resolves addresses when you look at the peer tab, if you switch away it pauses Link to comment Share on other sites More sharing options...
Stan Posted September 19, 2006 Author Report Share Posted September 19, 2006 no, solves the addresses slow. When Im on that tab...There is anyway to make uT 1.6 be like 1.5 on this or not? Link to comment Share on other sites More sharing options...
DreadWingKnight Posted September 19, 2006 Report Share Posted September 19, 2006 1.5 resolves addresses all the time.1.6 waits until you're looking at the tab.No Link to comment Share on other sites More sharing options...
Switeck Posted September 19, 2006 Report Share Posted September 19, 2006 Too much networking software+hardware could not handle the resolve ip load/rate that v1.5 had. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.