boxerriely Posted November 28, 2009 Report Share Posted November 28, 2009 i have searched everywhere. i have a actiontec modem M1000 connected to a Netgear router (WGR614v8). Witch one do i forward my ports in. Or is there some other setting either one must be set to. Thnaks for any help. Link to comment Share on other sites More sharing options...
GTHK Posted November 28, 2009 Report Share Posted November 28, 2009 Both. Link to comment Share on other sites More sharing options...
boxerriely Posted November 28, 2009 Author Report Share Posted November 28, 2009 still no open port. its wired when i set the modem to DMZ mode the port opens. Link to comment Share on other sites More sharing options...
GTHK Posted November 28, 2009 Report Share Posted November 28, 2009 If all your computers go through the router then DMZ in the modem is probably ok, otherwise, you need to portforward the modem to the routers external IP address, you can find the Netgears external address by finding the status page, look at the Internet or WAN section for IP Address. Link to comment Share on other sites More sharing options...
boxerriely Posted November 28, 2009 Author Report Share Posted November 28, 2009 thanks alot that was super helpful Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.